[Elecraft] RF Meter Doesn’t Move when radio set to 10 watts

[tomb18]

HiDo you have the 100w amp in the k3? Is it enabled in the menus? The meter reading switches at 10w so perhaps this is related? 73 Tom va2fsq.com 


Sent from my Samsung Galaxy smartphone.
-------- Original message --------From: usmcss <perry at spotlightdisplays.com> Date: 2018-07-11  3:59 PM  (GMT-05:00) To: elecraft at mailman.qth.net Subject: [Elecraft] RF Meter Doesn’t Move when radio set to 10 watts 
Been trying to figure out why every once in a while “Ext. Mic” will display
on the screen when transmitting. I’m working with Elecraft on it currently.

My question is; does anyone notice when you have the radio set to 10 Watts
the RF meter only shows on bar? When I set the radio below 9.8 watts the
meter always works fine.

I can adjust the mic gain up and down while set at 10 watts and the RF meter
will start moving again. Even when I put it back on the mic gain setting
that it wasn’t working on. But when I turn the radio off and back on the RF
meter doesn’t move unless I’m under 9.8 Watts? 

Even if I get the RF meter to start moving again when I adjust the mic
control, if I wait a little while it will stop moving. It does it with the
internal mic as well.

And just to be clear, this is happening when I push PTT and talk into mic.

Anyone have any idea on this? If you could check your radio I would
appreciate it.

Thank you!!!



--
Sent from: http://elecraft.365791.n2.nabble.com/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to tomb18 at videotron.ca