[Elecraft] Line Out Monitor Adjustment

[john at kk9a.com]

Thank you iain!  This is exactly what I was looking for.

John KK9A

Sent via the Samsung Galaxy 7 edge, an AT&T 4G LTE smartphone.

On Thu, Jan 18, 2018 at 11:24 PM, iain macdonnell - N6ML <ar at dseven.org>
wrote:

> On Thu, Jan 18, 2018 at 7:09 PM,  <john at kk9a.com> wrote:
> > I just upgraded my K3S's to the latest firmware. It is so easy, I should
> do
> > it more often. I have read that there is now a way to adjust the line out
> > monitor level however I cannot find documentation showing how this is
> done.
> > The default level is actually fine however I am curious where the Line
> Out
> > settings are.
>
> In the firmware release notes[1] under "K3 MCU 5.58 / DSP 2.88 / FPF
> 1.26, 3-16-2017":
>
> "* TX LINE OUT (MONITOR) LEVEL NOW ADJUSTABLE: In CONFIG:LIN OUT menu
> entry, tap '2'  (REV switch) to set the "T=" level (TX monitor). Tap
> '2' again to return to the RX LINE OUT setting."
>
> 73,
>
>     ~iain / N6ML
>
> [1] ftp://ftp.elecraft.com/K3/firmware/hfwnotes.rtf
>