[Elecraft] Line Out Monitor Adjustment

[iain macdonnell - N6ML]

On Thu, Jan 18, 2018 at 7:09 PM,  <john at kk9a.com> wrote:
> I just upgraded my K3S's to the latest firmware. It is so easy, I should do
> it more often. I have read that there is now a way to adjust the line out
> monitor level however I cannot find documentation showing how this is done.
> The default level is actually fine however I am curious where the Line Out
> settings are.

In the firmware release notes[1] under "K3 MCU 5.58 / DSP 2.88 / FPF
1.26, 3-16-2017":

"* TX LINE OUT (MONITOR) LEVEL NOW ADJUSTABLE: In CONFIG:LIN OUT menu
entry, tap '2'  (REV switch) to set the "T=" level (TX monitor). Tap
'2' again to return to the RX LINE OUT setting."

73,

    ~iain / N6ML

[1] ftp://ftp.elecraft.com/K3/firmware/hfwnotes.rtf