[Elecraft] K3 TX Calib Dummy Load Recommendations

[Bob McGraw K4TAX]

Try to find carbon resistors as newer film resistors may be reactive.    
Older carbon resistors have a tendency to migrate upwards in value.  Be 
sure to check them with a meter.

73
Bob, K4TAX



On 8/26/2018 7:50 AM, Bill Frantz wrote:
> For my KX3, I built a dummy load from three 150 ohm 2 watt resistors 
> and a BNC connector. The resistors are in parallel with a lead going 
> to the center conductor of the connector. The other leads are folded 
> back over the resistors and attached to the ground-side of the 
> connector. The whole outside is then covered with a piece of coax 
> braid. It does well on the antenna analyser test Bob, K4TAX suggests.
>
> It lives in a pocket of Rose's case and goes where the radio goes.
>
> 73 Bill AE6JV
>
> --------------------------------------------------------------------------- 
>
> Bill Frantz        |"After all, if the conventional wisdom was 
> working, the
> 408-356-8506       | rate of systems being compromised would be going 
> down,
> www.pwpconsult.com | wouldn't it?" -- Marcus Ranum
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net
>