[Elecraft] K3 TX Calib Dummy Load Recommendations

[Bill Frantz]

For my KX3, I built a dummy load from three 150 ohm 2 watt 
resistors and a BNC connector. The resistors are in parallel 
with a lead going to the center conductor of the connector. The 
other leads are folded back over the resistors and attached to 
the ground-side of the connector. The whole outside is then 
covered with a piece of coax braid. It does well on the antenna 
analyser test Bob, K4TAX suggests.

It lives in a pocket of Rose's case and goes where the radio goes.

73 Bill AE6JV

---------------------------------------------------------------------------
Bill Frantz        |"After all, if the conventional wisdom was 
working, the
408-356-8506       | rate of systems being compromised would be 
going down,
www.pwpconsult.com | wouldn't it?" -- Marcus Ranum