[Elecraft] KPA-1500 changes modes

[Tom]

HI,
My experience is that you should use OmniRig as the control in WSJT-X.  Do 
not use HamLib.
73

-----Original Message----- 
From: Richard Zalewski
Sent: Thursday, August 16, 2018 1:10 PM
To: Elecraft Reflector
Subject: [Elecraft] KPA-1500 changes modes

I have been experiencing an intermittent problem with the KPA-1500,
TS-990.  When running WSJT-X (USB) occasionally the 990 goes to AM-D1
mode.  No reason I can see for it to do that.  It does this in RECEIVE.
Just to be sure however I put lots of ferrite on all leads involved..

Richard
*W7ZR* ex:5C5Z, CN2ZR, K2JSP, W6SBZ, W7KXR, K9ZIJ, W9KNF, W0KDF, W0MQU,
J68ZR, KC6ZR, PJ4/W7ZR, KH2,W7ZR, KH6/W7ZR, V31ZR, VK4AAZ, XE2DV


*Be joyful in hope, patient in affliction, faithful in prayer*
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to tomb18 at videotron.ca 


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus