[Elecraft] K3S settings for Heil HM-10 XD microphone

[Bob McGraw K4TAX]

Does  Heil have the settings on their website? I seem to recall they do.  That is a good place to start. 

Bob, K4TAX


Sent from my iPhone

> On Aug 14, 2018, at 1:58 PM, Thomas Donohue <tomdon92 at gmail.com> wrote:
> 
> I recently purchased subject mic and will be connecting it to the K3S shortly. Before I do that, I was wondering what mic settings to use? I currently have a Heil PR-10 mic and am using the MIC FP HI menu setting and a mic gain of 20; the PR-10 works fine, but I wanted to get a mic that I could switch back and forth from the wide HC-5X cartridge to the narrow or DX HC-4X cartridge, thus the HM-10 XD. I have purchased the XLR 4 pin CC-1, connecting cable to replace the XLR 3 pin cable that I use with the PR-10 for connection to the FP Mic connector. The PR-10 has a 600 ohm balance impedance while the HM-10 XD has a 600 ohm impedance, unbalanced, I guess. To begin I intend to use the MIC FP HI menu setting. Does anyone see a problem with that or is there anyone using a HM-10 XD that can offer some suggested settings. Any response or info will be appreciated.
> 
> Best 73,
> Tom/W1QU 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to rmcgraw at blomand.net
>