[Elecraft] KXFL3 Installation Questions

[Petr, OK1RP/M0SIS]

Hi,

do not worry, nothing goes wrong with your KXFL3 when last 2 pins are
removed. 

The removing pins (10), 11, 12 is the hardware modification described below
as an alternative for those who have the KXFL3 module... 

See KX3 VFO Tuning Noise Suppression Modification:
http://www.elecraft.com/manual/KX3%20Tuning%20Noise%20Mod%20rev%20B3.pdf

"If pins 11 and 12 of the 12-pin connector have been removed from the board,
the KXFL3 has been modified. Even though the modification discussed in this
document removes a third pin as well, the factory's mod achieves the same
results by removing a component from the PC board."

Hope it helps,

73 - Petr, OK1RP
(ex KL7/OK1RP at Fairbanks/Prudhoe Bay)




-----
http://ok1rp.blogspot.com
--
Sent from: http://elecraft.365791.n2.nabble.com/