[Elecraft] K3 macro to tune memories from K-pod

[Chuck Teague]

 I did check my  firmware revision numbers, and have 5.62 and 1.09 in the
K-pod.

In my original post I stated that after sending the M>V macro (which does
bring up the flashing memory number) that pressing the Up or DN macro
caused the display to revert to its original frequency and nothing else
happens.. That's not quite right. Subsequent sends of the UP or Dn macros
cause VFO A to increment or decrement.  But sending either the Up or Dn
from the K-pod kicks the K3 out of memory mode.  Everything works perfectly
from the utility, so it seems to be a K-pod issue.

Chuck, NN7U