[Elecraft] 60 meters and the K3S

[Fred Jensen]

I used the K3 Memory Editor and set up the 5 "channels" for both CW and 
SSB.  Worked really slick and I could give them meaningful names that 
appear in VFO B.  It's on the Elecraft site, "K3/K3s, KX3, and K2 
Control Software."  The memories contain both VFO A and B data, so you 
can set up one for SSB and one for CW or maybe PSK31.  You can even do 
split, CTCSS tones, etc.  There are a half-million [or so] memories so 
you're not likely to run out.

Note: Part 97 uses the term "RTTY" for an authorized emission on 60 
meters, but the emission designator sure looks like PSK31, not 170 Hz FSK.

73,

Fred ["Skip"] K6DGW
Sparks NV DM09dn
Washoe County

On 9/29/2017 1:20 PM, w1rm at comcast.net wrote:
> Some time back there was some great information on setting up the K3(s) to
> operate on 60 meters.  It involved saving the frequencies in memories and
> recalling them.  I had my K3 set up that way but with the K3S changeover,
> that's gone and I can't seem to find that information on the web (perhaps
> I'm not searching on the right terms).
>
>   
>
> Does anyone remember that and can point me in the right direction?
>