[Elecraft] K1 and DMM resistance checks

[Art Hejduk]

Roney,

If it is an auto-ranging meter, it is okay.  1 just means open, which is
greater than 100k ohms.  If it is not an auto-ranging meter, make sure you
select a range that will measure at least up to 100k ohms.  Again, 1 would
be okay.

73,
Art  WB8ENE

On Mon, May 22, 2017 at 9:13 AM, roney <roneymonte at gmail.com> wrote:

> Hello, I'm just building my first K1.
>
> Everything is going right, I had already build the filter board, the front
> panel, and now in main board.
>
> I have a question about resistance checks using DMM:
>
> - Every time when the manual says that in some point the resistance must be
> > 100K, my multimeter shows 1, just like there was no resistance. Is that
> right ?
>
> For all other resistance checks in specific values or ranges, it's working
> as expected.
>
> I just need to solve this doubt in order to proceed.
> (now I'm on page 29 from manual)
>
> Thanks and 73
> Roney Monte (PY1ZB)
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to valvetbone at gmail.com
>