[Elecraft] K1 and DMM resistance checks

[roney]

Hello, I'm just building my first K1.

Everything is going right, I had already build the filter board, the front
panel, and now in main board.

I have a question about resistance checks using DMM:

- Every time when the manual says that in some point the resistance must be
> 100K, my multimeter shows 1, just like there was no resistance. Is that
right ?

For all other resistance checks in specific values or ranges, it's working
as expected.

I just need to solve this doubt in order to proceed.
(now I'm on page 29 from manual)

Thanks and 73
Roney Monte (PY1ZB)