[Elecraft] K3 Main Encoder

[Don Wilhelm]

Bill,

That sounds like what can happen if the nut(s) on the encoder shaft 
bearing are not tight.

73,
Don W3FPR

On 5/5/2017 6:47 AM, Bill W4ZV wrote:
> I recently bought a relatively new K3 (#8641).  In the process of adjusting
> the Main VFO drag, I noticed the shaft has some minor (few mm?) slippage
> (perpendicular to the front panel).  Is this normal on recent K3 units or is
> it a defective encoder?