[Elecraft] K3 Main Encoder

[Bill W4ZV]

I recently bought a relatively new K3 (#8641).  In the process of adjusting
the Main VFO drag, I noticed the shaft has some minor (few mm?) slippage
(perpendicular to the front panel).  Is this normal on recent K3 units or is
it a defective encoder?  

Or is it a design "feature" to adjust the drag with the knob in and then
pull it out if I want it to spin fast freely.  (GRIN)

73,  Bill  W4ZV



--
View this message in context: http://elecraft.365791.n2.nabble.com/K3-Main-Encoder-tp7630319.html
Sent from the Elecraft mailing list archive at Nabble.com.