[Elecraft] K3S and Winlink

[Barry]

Tom,
     I'm not sure which Winlink software you are running, but it should 
work. Check to see that you have VOX on so that when you start to send 
tone the radio goes into transmit. If that is OK, you may need to tell 
your software to use software control for PTT.

73,
K3NDM
Barry

------ Original Message ------
From: "Tom S Bingham" <tom at wb7eux.net>
To: elecraft at mailman.qth.net
Sent: 3/28/2017 9:25:09 PM
Subject: [Elecraft] K3S and Winlink

>I have installed the Winlink software but I cannot place my K3S into 
>transmit when using the Winmor protocol.  The channel selection feature 
>changes frequencies on the rig properly.  And, when I place the K3S 
>into transmit manually, the modem tones cause ALC to register.
>
>As a side note, Fldigi works fine.  Both Winlink and Fldigi are set to 
>the same COMM port and the K3S is in USB mode with under CONFIG:RS232.  
>Fldigi is not running when I use the Winlink software.  I use the 
>Elecraft supplied KUSB cable between the computer and the K3S.
>
>Can anyone give me a clue?
>
>Thanks!
>Tom
>
>-- Tom Bingham WB7EUX
>http://www.wb7eux.net/
>SKCC 9833S
>NAQCC 6346
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
>Message delivered to k3ndm at comcast.net