[Elecraft] K3S and Winlink

[Tom S Bingham]

I have installed the Winlink software but I cannot place my K3S into 
transmit when using the Winmor protocol.  The channel selection feature 
changes frequencies on the rig properly.  And, when I place the K3S into 
transmit manually, the modem tones cause ALC to register.

As a side note, Fldigi works fine.  Both Winlink and Fldigi are set to 
the same COMM port and the K3S is in USB mode with under CONFIG:RS232.  
Fldigi is not running when I use the Winlink software.  I use the 
Elecraft supplied KUSB cable between the computer and the K3S.

Can anyone give me a clue?

Thanks!
Tom

-- 
Tom Bingham WB7EUX
http://www.wb7eux.net/
SKCC 9833S
NAQCC 6346