[Elecraft] KX3/KXPA100 Change

[Don Pomplun]

Elecraft CS suggested wiggling the RJ connector, too, but I found the 
problem was wiggling the 2 plugs at the other end of the cable.

Also [egg on face] I once had one of those plugs plugged into the RX I/Q 
jack instead of ACC

Don   K2BIO


On 03/04/2017 05:42 PM, Don Wilhelm wrote:
> Carter,
>
> As a first step:
> Check the seating of all the plugs, give them that 'extra push'.
> The is especially true of the RJ-45 plug.  Remove it and make certain 
> it goes back in with a little click.
>
> 73,
> Don W3FPR
>
> On 3/4/2017 3:48 PM, Carter Craigie wrote:
>> Hello Fellow Elecrafters,
>> I have an Elecraft KX3, connected to an Elecraft PX3, and both are 
>> connected
>> to an Elecraft KXPA100 Amplifier, and to my Dell laptop computer.
>> All had been working well, and before leaving for an out-of-state 
>> trip, I
>> disconnected the antenna cable from the rig, as well as the power 
>> cable. I
>> may have disconnected something else, but all cables are now 
>> connected right
>> where they should be now.
>> Upon returning from the trip, and re-plugging everything, I can get 
>> no more
>> than 5 Watts out of the KX3.
>> The green LEDs illuminate on the KXPA100 Amplifier, and the Switch is 
>> in the
>> OFF position. The KX3 is receiving properly with good audio, and all 
>> signals
>> show correctly on the PX3.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to radioprincegeorge at gmail.com