[Elecraft] KX3/KXPA100 Change

[Don Wilhelm]

Carter,

As a first step:
Check the seating of all the plugs, give them that 'extra push'.
The is especially true of the RJ-45 plug.  Remove it and make certain it 
goes back in with a little click.

73,
Don W3FPR

On 3/4/2017 3:48 PM, Carter Craigie wrote:
> Hello Fellow Elecrafters,
> I have an Elecraft KX3, connected to an Elecraft PX3, and both are connected
> to an Elecraft KXPA100 Amplifier, and to my Dell laptop computer.
> All had been working well, and before leaving for an out-of-state trip, I
> disconnected the antenna cable from the rig, as well as the power cable. I
> may have disconnected something else, but all cables are now connected right
> where they should be now.
> Upon returning from the trip, and re-plugging everything, I can get no more
> than 5 Watts out of the KX3.
> The green LEDs illuminate on the KXPA100 Amplifier, and the Switch is in the
> OFF position. The KX3 is receiving properly with good audio, and all signals
> show correctly on the PX3.