[Elecraft] K3 s/n 8xxx won't do 50 W TX gain calibration

[Don Wilhelm]

Brian,

I think that may be a K3 Utility "problem".
It has the capability to skip any of the gain calibration ranges.  Try 
again and observe all the buttons on each screen.

73,
Don W3FPR

On 6/8/2017 3:12 PM, brian wrote:
> It's been a bit since I've done this.
> 
> It does the 5 watt calibration OK.
> 
> It then goes to the 50 watt calibration menu.  Hitting next doesn't do 
> any calibration but instead brings up the 1 mW calibration menu.
> 
> K3 with new synthesizers:  FW 5.57/1.26/2.88/2.88
> 
> Only thing I can recall happening since the last time it worked was 
> upgrade to 5.57 et al.




> 
> ????
> 
> de Brian/K3KO
> 
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to donwilh at embarqmail.com
>