[Elecraft] KAT500 Utility problem

[Harry Yingst]

I'm running the latest ver 5.54 on my K3 and ver1.75 on my KAT500 and I do hear the relays click as I tune
But you do need to pause on a frequency for them to click (they don't switch while tuning)





      From: George Kidder <gkidder at ilstu.edu>
 To: 'Elecraft Reflector' <elecraft at mailman.qth.net> 
 Sent: Wednesday, January 11, 2017 2:56 PM
 Subject: [Elecraft] KAT500 Utility problem
   
Hi gang,

I hope this is a minor problem, but I cannot seem to solve it.  I have a 
K3 running 5.53 firmware, and a recently acquired KAT500. They are 
connected as in Figure 2 of the KAT500 manual, using the KPAK3AUX cable 
with the key line interrupter, and a separate key line to activate my 
AL-80A amplifier.  Everything seems to work "just as per" with the 
exception of the frequency tracking function on receive.  This was 
running at one time; I did a tune every time the K3 crossed a frequency 
boundary, and it seemed to track thereafter.  Now it won't track - no 
relay noise from one end of the band to the other.  It seems to remember 
specific settings, and will re-tune on transmit, but does not re-tune on 
VFO movement.  (No split freq, either.)  There is no KAT3 in the K3, so 
CONFIG:KAT3 indicates "not inSt", but tap 1 toggles getween KAT500N and 
KAT500Y, and was left in the latter position.

This is no big deal, but it would be handy if the KAT500 would return on 
receive to the last settings for that frequency, rather than wait for a 
transmit pulse.  Besides, it is supposed to do just that!

Any thoughts?

George, W3HBM

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to hlyingst at yahoo.com