[Elecraft] Question re KX2 and KXPA100

[Don Wilhelm]

David,

I don't know the KX2 well enough to give you even a guess, although it 
is obvious that something is putting the KXPA100 into transmit.  Do you 
have the ACC plug fully inserted - give it that extra bit of push.

But something is apparently wrong, and I suggest you contact K3support 
at Elecraft.

73,
Don W3FPR

On 2/27/2017 1:38 PM, david perry wrote:
> Hi Folks
> Quick question for you.
>
> I have a KX3 (three) and a KX2 (two) and a KXPA100.
>
> The kx3 and pa100 work fine.
>
> However, when I use the kx2 it isnt fine.  I set AUX2 to ON, PA to ON and
> all is well UNTIL I go over 10 watts.  When I go above ten watts on the
> dial setting on the kx2 the TX light on the PA comes on and of course my Rx
> goes deaf.  Wind it back to below 10 watts or below and the relay in the PA
> clicks and the Rx works again.
>