[Elecraft] Question re KX2 and KXPA100

[david perry]

Hi Folks
Quick question for you.

I have a KX3 (three) and a KX2 (two) and a KXPA100.

The kx3 and pa100 work fine.

However, when I use the kx2 it isnt fine.  I set AUX2 to ON, PA to ON and
all is well UNTIL I go over 10 watts.  When I go above ten watts on the
dial setting on the kx2 the TX light on the PA comes on and of course my Rx
goes deaf.  Wind it back to below 10 watts or below and the relay in the PA
clicks and the Rx works again.

Ive got latest firmware in KX2 and PA100.


What am I missing?

David G4YVM