[Elecraft] KX3 2M module install -- HELP

[GRANT YOUNGMAN]

Yes, several times.  Just looks like a minor glitch.  See my note below.

Thanks … Grant NQ5T


> On Feb 3, 2017, at 3:51 PM, GRANT YOUNGMAN <ghyoungman at gmail.com> wrote:
> 
> Never mind …
> 
> Apparently it was just some garbage in VFO A.  VFO B was on 144.00 where it should have been.  A swap and copy of VFOs fixed the problem.
> 
> 
>> On Feb 3, 2017, at 3:37 PM, GRANT YOUNGMAN <ghyoungman at gmail.com> wrote:
>> 
>> Before I call tech support, thought I’d try here.
>> 
>> Just installed in the 2M module in my KX3. I’m on the latest firmware rev.  Gone over the setup instructions several times, and the parameters are all set properly — enabled, 50 Mhz IF, in the band map, etc.
>> 
>> When I go to the 2M band, the display comes up 122.000.00  ?????
>> 
>> Anyone have an idea?
>> 
>> Thanks ...
>> Grant NQ5T
>> K3 #2091, KX3 #8342
>> 
>> 
>> 
> 
> Grant NQ5T
> K3 #2091, KX3 #8342
>