[Elecraft] KX3 2M module install -- HELP

[GRANT YOUNGMAN]

Never mind …

Apparently it was just some garbage in VFO A.  VFO B was on 144.00 where it should have been.  A swap and copy of VFOs fixed the problem.


> On Feb 3, 2017, at 3:37 PM, GRANT YOUNGMAN <ghyoungman at gmail.com> wrote:
> 
> Before I call tech support, thought I’d try here.
> 
> Just installed in the 2M module in my KX3. I’m on the latest firmware rev.  Gone over the setup instructions several times, and the parameters are all set properly — enabled, 50 Mhz IF, in the band map, etc.
> 
> When I go to the 2M band, the display comes up 122.000.00  ?????
> 
> Anyone have an idea?
> 
> Thanks ...
> Grant NQ5T
> K3 #2091, KX3 #8342
> 
> 
> 

Grant NQ5T
K3 #2091, KX3 #8342