[Elecraft] K3 loss of rx signal

[Don Wilhelm]

Phil,

PL-259s depend on tightness to make a good connection to the shield.
This is an often overlooked cause of problems.
After hand tightening, snug them up just a bit more with pliers if you 
want them to be reliable.

73,
Don W3FPR

On 4/3/2017 10:19 AM, Phil Hystad wrote:
>
>> On Apr 3, 2017, at 5:25 AM, Nr4c <nr4c at widomaker.com> wrote:
>>
>> Don't overlook the obvious.  Check to make sure the connectors are all very tight. "Hand snug" is not good enough!
>>
>> Sent from my iPad
>> ...bc nr4c
>
> What do you mean “Hand Snug” is not good enough?