[Elecraft] K3 loss of rx signal

[Phil Hystad]

> On Apr 3, 2017, at 5:25 AM, Nr4c <nr4c at widomaker.com> wrote:
> 
> Don't overlook the obvious.  Check to make sure the connectors are all very tight. "Hand snug" is not good enough!
> 
> Sent from my iPad
> ...bc nr4c

What do you mean “Hand Snug” is not good enough?  I don’t remember any connectors in the K3 that required a wrench to tighten nor do I ever use any wrenches or even screwdrivers on any of the connectors outside the box (Coax, RS232 serial, etc.).

Curious in Rainy Kirkland (nr Seattle)…

73, phil, K7PEH