[Elecraft] Commander in DxLab locking up

[Jerry]

I have been successfully using DxLab as my logging/control program for my K3S for a few months now. About 2 weeks ago and again yesterday the Commander module locks up. If I am not attentive it ends up logging contacts on the 'locked up' freq and mode.
I am using a new HP computer in the shack with Windows 10 connecting to the K3S with the USB port.
The applications manager is unable to force Commander down. The only choice I have is to close everything else n then manually turn off the computer. When it reboots all is good.
I have started to shut down Commander when I shut off the K3S - the computer runs 24/7 as there are scripts running for auto backup to my NAS.
My issue sounds somewhat familiar to a recent post here.
Any suggestions where to start?




Life is short
Ride hard