[Elecraft] New KSYN3a installed and not working / recognized

[Don Wilhelm]

Michael,

Check and recheck the plugging of the TMP cables. Make sure the TMP 
connectors are fully seated.  The cables must match that shown in Figure 
12 on page 16 of the installation instructions.

Did you exit the menu after turning Tech Mode on?  If not, you need to 
do that and try again.

If no luck, contact Elecraft support for additional help and resolution.

73,
Don W3FPR

On 10/8/2016 4:18 PM, Michael via Elecraft wrote:
> I just installed the new KSYN3a and when I turn on my K3/100/2M rig it does
>  not seem
> to recognize the board. With "TECHMD ON" and pressing the display  button
> and rotating VFO B knob I
> do not see SYN1 in the VFO B part of the display!
>
> Also there is no LED light coming on - on the KSYN3a board at all.
>