[Elecraft] K3 and Signallink next the Microham

[Joe Subich, W4TV]

 > Next to try and set up the microham for digital work.

Which microHAM Interface?

In general, set the K3/K3S to DATA mode and select MENU:MIC SEL =
LINE IN, set Mic Gain (LINE) to about 15 and configure the microHAM
interface audio levels as documented in the "Setting Audio Levels"
section of the microHAM Users Manual.  As a final "touch up" adjust
the K3 "Mic Gain" for four bars of ALC (the fifth bar can flicker).


73,

    ... Joe, W4TV

On 5/29/2016 6:54 PM, Ross wrote:
> Thanks for all the comments about the signal link.
> I found the problem when checking Airlink express, I had the volume and tx levels set to almost zero, in Airlink express so whenI reset them to max, everything popped into life and all my other digital programs then worked perfectly.
>
> Next to try and set up the microham for digital work.
> All advice very gratefully accepted.
> Thanks
> Ross
> ZL1WN
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to lists at subich.com
>