[Elecraft] FLDIGI and K3

[Jerry Moore]

I run on a raspberry pi under linux. Hardware Comm


On May 23, 2016 5:17:53 PM EDT, Bob Darlington <rdarlington at gmail.com> wrote:
>Are you using virtual com port software that's not up and running
>before
>you start fldigi?  Are you saying "yes" to the save settings popup when
>closing after you fix the problem?
>
>-Bob
>
>On Mon, May 23, 2016 at 3:13 PM, Paul Christensen <w9ac at arrl.net>
>wrote:
>
>> Dave,
>>
>> Correct.  I must always initialize Fldigi with my K3.  Once
>initialized,
>> it's works fine.  If I close it and re-open, initializing is needed
>again.
>>
>> Paul, W9AC
>>
>> On Mon, 2016-05-23 at 13:19 -0400, Paul Christensen wrote:
>> > Jerry,
>> >
>> > Thanks for the tip.  I'll use a macro in Fldigi if there's no
>simple
>> > solution available.
>> >
>> > Paul, W9AC
>>
>> Paul,
>>
>> If I understand you correctly, you set things up in FLDigi, get them
>> working, and then if you close the program, and restart it, the rig
>is
>> no longer controlled.  Is that correct?
>>
>>
>>
>> --
>> 73's, and thanks,
>> Dave (NK7Z)
>> For software/hardware reviews see:
>> http://www.nk7z.net
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to rdarlington at gmail.com
>>

-- 
Sent from my Android device with K-9 Mail. Please excuse my brevity.