[Elecraft] FLDIGI and K3

[Paul Christensen]

>”Are you using virtual com port software that's not up and running before you start fldigi?  Are you saying "yes" to the save settings popup when closing after you fix the problem?

 

-Bob”

 

Physical COM port connected to the K3.  It’s an FTDI USB-toRS232 media converter that works fine with anything else connected to the K3.  

 

Yes, have attempted to save the Fldigi configuration in the pop-up a countless number of times.

 

Paul, W9AC 

 

On Mon, May 23, 2016 at 3:13 PM, Paul Christensen <w9ac at arrl.net <mailto:w9ac at arrl.net> > wrote:

Dave,

Correct.  I must always initialize Fldigi with my K3.  Once initialized,
it's works fine.  If I close it and re-open, initializing is needed again.

Paul, W9AC

On Mon, 2016-05-23 at 13:19 -0400, Paul Christensen wrote:
> Jerry,
>
> Thanks for the tip.  I'll use a macro in Fldigi if there's no simple
> solution available.
>
> Paul, W9AC

Paul,

If I understand you correctly, you set things up in FLDigi, get them
working, and then if you close the program, and restart it, the rig is
no longer controlled.  Is that correct?



--
73's, and thanks,
Dave (NK7Z)
For software/hardware reviews see:
http://www.nk7z.net

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net <mailto:Elecraft at mailman.qth.net> 

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to rdarlington at gmail.com <mailto:rdarlington at gmail.com>