[Elecraft] K3 Transmitting CW in SSB mode

[Ron D'Eau Claire]

Exactly Grant. Many of the early SSB rigs were basically SSB-only. So adding
a tone to the SSB signal was the simplest way to send "cw". But the opposite
sideband suppression is never perfect - too often far from it. 

That was no big deal back when over half of the signals on a "phone" band
were 6 kHz wide AM signals. 

73 Ron AC7AC

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Grant
Youngman
Sent: Wednesday, July 27, 2016 3:10 PM
To: gkidder at ilstu.edu
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 Transmitting CW in SSB mode

It's just a"few lines of code" ;) 

All done in DSP most likely.  Simpler than doing the same thing in an analog
radio. 

Grant NQ5T