[Elecraft] K3 Transmitting CW in SSB mode

[HankP]

While we are on this subject - is there a way to have CW+SSB on the split frequency as in using the subrx for split freq and want to get a carrier with key ? I have tried b SET and A>B ALL etc etc . You CAN get it by an A/B and turning off split but would be handy to simply have it on both VFOs. Hank K7HP ----- Original Message -----
> With CW+SSB turned on, SSB will be sent at the carrier frequency
> indicated on the VFO.
> When CW is sent, the frequency is shifted by the amount of your
> sidetone pitch, so the receiving station will hear a pitch equal to
> your
> sidetone pitch.
> Note that for normal CW, the signal frequency is the same as indicated
> on the VFO, i.e. it is different in CW+SSB.
> If you are sending in CW mode and the receiving station is listening
> in
> SSB - and both VFOs are tuned to the same frequency, they will hear
> nothing because their receiver will likely not hear a signal at the
> carrier frequency - that does assume that both stations VFOs are
> calibrated properly.
> 73,
> Don W3FPR