[Elecraft] Power has disappeared, additional info, part 2.

[Chris Kimball]

Thanks for the comments. 

The rig is NOT in the TEST mode, that is, the display TX is not flashing. 
Holding the TEST mode produces informative messages in the VFO B area both
on turn on and turn off.  I'm not certain that the TEST mode produces ANY
indication at all in the RF scale.

I've bypassed both the KPAT and KAT and set the power to 10W.  Into a dummy
load I still get just one segment in the RF output, the segment being about
twice the width of the end tick on the RF scale.  There is a distinctive
click in going below 13W output.

The rig has only 1 receiver and that receiver has the general coverage
option. I've tried operating on 80, 40, and 20m with the same no-output
result.

Just reloaded the latest firmware with K3 Utility. No change in RF output,
unfortunately.



--
View this message in context: http://elecraft.365791.n2.nabble.com/Power-has-disappeared-tp7620735p7620752.html
Sent from the Elecraft mailing list archive at Nabble.com.