[Elecraft] Diversity Mode filter selection question

[Arie Kleingeld PA3A]

Hello Bill,

During normal operation there a no clicks when changing a filter.

My K3 is an older one, but ever since I have the NEW SYNTH's on board, 
there's a lot of clicking going on when I change the width of the 
filters in Diversity mode.

Nothing to worry about. I think the relays are on the new Synt-boards?  
Everything works. The diversisty is brilliant.

73
Arie PA3A



Op 24-2-2016 om 0:53 schreef Bill OMara via Elecraft:
> I'm the proud owner of four K3 radios at my contest station and one of my
> new K3 (89XX) is doing something different than the other three and I'm
> trying to understand what it's doing.
>
>   
>
> In the diversity mode as I change the width control and reach the selection
> points for different CW filters to be selected I hear what sounds like two
> (one after the other) clicks of what I'm guessing is the two new filters
> being selected as the width is either decreased of increased. This same dual
> clicking sounds happen at each filter selection point.
>
>   
>
> What's weird is that the other three K3 radio don't do this.  Is it a
> different configuration setting?  If so, what is the configuration setting?
>
>   
>
> This same radio doesn't make any clicking sound when changing the width
> control, filters when it's NOT in diversity mode.
>
>