[Elecraft] Best Coax for Jumpers and Interconnections for SO2R operation with K3 & KX3

[David Kuechenmeister]

Best possible could run into some money. You can get Pasternack to build a 36 in. jumper from RG223 ( double shielded and very small bend radius) for about $35. You can buy the parts for about $22 and DIY. http://www.pasternack.com/showProduct.aspx?SEName=uhf-male-uhf-male-rg223u-cable-assembly-pe3w00408&ProductID=

But I think LMR-240 UF is pretty good. It's got a foil and braid shield. It's what I use and I crimp/solder UHF connectors that I get from Max-Gain systems.
The sheathing on the bury flex is a little stiffer than I like to deal with.
vy 73,Dave N4KD 

    On Tuesday, February 23, 2016 12:12 PM, Robert Nobis <n7rjn at nobis.net> wrote:
 

 I am in the process of setting up my shack for SO2R operation with my K3 and KX3.  Just wondering what the best coax type to use for jumpers and interconnections within the shack?  I want to make sure I have the best possible isolation between the two rigs. 

Thanks and 73,


Bob Nobis - N7RJN
n7rjn at nobis.net


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to n4kd at bellsouth.net