[Elecraft] K3 Configuration to KS3

[Ed Muns]

The K3 Utility reads the serial number and will only restore to the same radio.

73,
Ed W0YK
On Feb 12, 2016 14:04, Bill W4ZV <btippett at alum.mit.edu> wrote:
>
> Gary Smith-2 wrote 
> > - Will I encounter any unexpected problems if I load my K3 
> > configuration to the K3s and start operating? 
>
> Probably...because Config Save will copy your K3 calibration constants into 
> the K3S.  You would at least need to go through all calibration steps again.  
> I doubt the K3 Utility will even allow you to copy K3 settings into the K3S 
> but I honestly don't know.  Hopefully someone from Elecraft will respond. 
>
> You do bring up a good point that it would be nice to have a Config Save 
> Lite that would affect only common menu choices for the K3/K3S but not 
> calibration constants and items unique to the K3.  I doubt Elecraft has 
> thought of this but it would be nice if possible. 
>
> If I were you I'd go through the K3 CONFIG settings, write everything down 
> and then manually duplicate into the K3S.  Also don't forget the MENU 
> settings. 
>
> 73,  Bill  W4ZV 
>
>
>
> -- 
> View this message in context: http://elecraft.365791.n2.nabble.com/K3-Configuration-to-KS3-tp7613960p7613964.html 
> Sent from the Elecraft mailing list archive at Nabble.com. 
> ______________________________________________________________ 
> Elecraft mailing list 
> Home: http://mailman.qth.net/mailman/listinfo/elecraft 
> Help: http://mailman.qth.net/mmfaq.htm 
> Post: mailto:Elecraft at mailman.qth.net 
>
> This list hosted by: http://www.qsl.net 
> Please help support this email list: http://www.qsl.net/donate.html 
> Message delivered to ed at w0yk.com