[Elecraft] K3 Configuration to KS3

[Fred Jensen]

I think the Config Save function in the K3 Utility saves the serial 
number too, and only will load back into the same S/N.  A way to save 
only parameters that are not S/N dependent for transfer between radios 
would indeed be nice.

73,

Fred K6DGW
Sparks NV
Washoe County DM09dn

On 2/12/2016 10:04 AM, Bill W4ZV wrote:
> Gary Smith-2 wrote
>> - Will I encounter any unexpected problems if I load my K3
>> configuration to the K3s and start operating?
>
> Probably...because Config Save will copy your K3 calibration constants into
> the K3S.  You would at least need to go through all calibration steps again.
> I doubt the K3 Utility will even allow you to copy K3 settings into the K3S
> but I honestly don't know.  Hopefully someone from Elecraft will respond.
>
> You do bring up a good point that it would be nice to have a Config Save
> Lite that would affect only common menu choices for the K3/K3S but not
> calibration constants and items unique to the K3.  I doubt Elecraft has
> thought of this but it would be nice if possible.
>
> If I were you I'd go through the K3 CONFIG settings, write everything down
> and then manually duplicate into the K3S.  Also don't forget the MENU
> settings.
>
> 73,  Bill  W4ZV