[Elecraft] K3 - KIO3B setup

[N2TK, Tony]

I tried installing the USB cable from the K3 to the PC. The only thing that
happens is that in Device Manager >Universal Serial Bus Controllers it show
two USB ports added - Generic USB Hub and USB Composite Device. What do I do
next?
How do I get this tied into LP-Bridge as before as there is nothing showing
on LP-Bridge how to handle USB connections? 

Tnx for any input.

N2TK, Tony

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of N2TK,
Tony
Sent: Monday, January 18, 2016 4:25 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 - KIO3B setup

I installed the KIO3B kit. I have it set up as the original KIO3 - K3- RS232
to P3 to PC/SteppIR. Accessory plug with FSK interface and audio in and out
cables to audio board. I use LP-Bridge. Everything is working fine as it was
before the upgrade.

Now I want to take advantage of the features of the KIO3B kit.

 

I have the CBLP3Y cable for the K3 to the P3. 

I will replace the RS232 with the USB to the PC.

I will remove the audio in and out cables. 

 

Is there anything special I need to do now that I will be using a USB port
instead of the RS232? 

What about with LP-Bridge? Anything I need to do with it? 

Where is the best place to hook up the SteppiR now that I don't have an
RS232 connecting to the PC?

 

Tnx for any feedback.

73,

N2TK, Tony

 

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to tony.kaz at verizon.net