[Elecraft] KXPA100 with PX3

[Dave AD6A]

You may simply have the power set too low (below 11W) for the KXPA100 to turn on. 

73 Dave AD6A

Sent from my  iPhone 5s

> On Dec 30, 2016, at 9:22 AM, Don Wilhelm <donwilh at embarqmail.com> wrote:
> 
> Ray,
> 
> Check to be certain the RJ-45 connectors are fully plugged in.  Some of them are difficult to seat if you hold onto the cover boot.  Pull the boot back and push the plug itself in until it clicks.
> 
> Make sure the other plugs are fully seated - give them an extra push into their jacks.
> 
> 73,
> Don W3FPR
> 
>> On 12/30/2016 11:50 AM, Ray W2RS via Elecraft wrote:
>> The KX3 says it has the KXPA100 behind it, but I still get no output.  When I turn PA MODE to OFF, and turn the amp ON using the front panel switch, I get full output but in Basic mode.
>> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at ad6a.com