[Elecraft] KXPA100 with PX3

[Don Wilhelm]

Ray,

Check to be certain the RJ-45 connectors are fully plugged in.  Some of 
them are difficult to seat if you hold onto the cover boot.  Pull the 
boot back and push the plug itself in until it clicks.

Make sure the other plugs are fully seated - give them an extra push 
into their jacks.

73,
Don W3FPR

On 12/30/2016 11:50 AM, Ray W2RS via Elecraft wrote:
> The KX3 says it has the KXPA100 behind it, but I still get no output.  When I turn PA MODE to OFF, and turn the amp ON using the front panel switch, I get full output but in Basic mode.
>