[Elecraft] KXPA100 with PX3

[Cady, Fred]

Make sure all of the plugs are fully seated in their sockets.

73,

Fred KE7X


For all KE7X Elecraft books, see www.ke7x.com


________________________________
From: Elecraft <elecraft-bounces at mailman.qth.net> on behalf of Ryan Noguchi via Elecraft <elecraft at mailman.qth.net>
Sent: Friday, December 30, 2016 8:38 AM
To: rsoifer1 at aol.com; elecraft at mailman.qth.net
Subject: Re: [Elecraft] KXPA100 with PX3

>>http://www.elecraft.com/manual/PX3_installation_FAQ_v-0-8.pdf  see Figure 3.
>When I tried that, I got no output from the KXPA100 with the KX3 PA MODE set to ON.  If I set that to OFF, I get full output but then not full interaction with the KX3.  What am I doing wrong?

So are you saying that you have the KX3, PX3, and KXPA100 all connected in the exact manner depicted in Figure 3 (which also appears in the PX3 manual) and you're still experiencing this problem? Maybe I'm mistaken, but it sounds like you aren't using the KX3-KXPA100 adapter cable. You can't just connect the KXPA100 RS232 port directly to the KX3 ACC1 port.

73, Ryan AI6DO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to fcady at montana.edu