[Elecraft] KX3 and FLDIGI

[Nr4c]

You're only using one of the signals, either I or Q and  at very low level. I believe you'd get better service with the phones output. Fldigi is only looking at the tip signal 

Sent from my iPhone
...nr4c. bill


> On Dec 2, 2016, at 2:57 PM, John Pitz <crustacean at brig-elec.com> wrote:
> 
> 
> I have been and it seems to work just fine.  I have made contacts using
> that setup with PSK31 and have decoded PSK31, RTTY, as well as one other
> mode-can't remember which at the moment.  I have also been told rather
> emphatically that fldigi would not work with the IQ signal.  My
> experience is it works just fine.  The width of the spectrum is quite a
> bit less than what I think a full panadaptor would give.
> 
> 
> 
>> On Fri, 2016-12-02 at 14:43 -0500, Kevin - K4VD wrote:
>> 
>> When using the KX3 with fldigi can I use the RX I/Q output from the radio
>> to the computer? I can't find any reference to i/q in the fldigi docs so
>> I'm assuming the answer is no but thought I'd ask before giving up.
>> 
>> Kev K4VD
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to crustacean at brig-elec.com
>> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to nr4c at widomaker.com