[Elecraft] KX3 Meter Display Question

[Don Wilhelm]

Jim,

No, the display will normally go back to displaying the RF level.

After setting the audio level to the KX3 (K3 or K3S), that level is not 
going to change unless you make some changes to the computer audio 
level.  If you do that, just change the MIC GAIN knob a little bit and 
the display will revert to the ALC/COMP display.

73,
Don W3FPR


On 8/12/2016 10:02 PM, James Bennett wrote:
> OK - I’m officially stumped. How does one keep the meter display showing ALC continuously instead of RF output? When I operate the digital modes, in DATA-A, I want to have the ALC displayed so that I can keep an eye on making sure that 5th bar is just flickering. There is a difference in setting the Mic gain between JT65 and JT9, so this is something I like to monitor. However, after setting the MIC gain to the proper ALC level the display insists on jumping back to RF output. Is there a way to stop this from happening?
>