[Elecraft] P3 Display of split

[Dave Cole]

Hi Tony,

I use this macro for split and it works for me:

BW0001;SWT13;SWT13;FT1;UPB7;RT0;XT0;#SPN000060;#RCF+002500;BW0280;

BW 	Sets bandwidth to as narrow as possible...

SWT13 	Copies the current vreq to VFO B

FT1 	Selects VFO A

UPB7 	Moves the VFO A up 5

RT0/XT0 Clear RIT and XIT

SPN 	Sets the P3 span to 6 KHz

RCF 	Offsets the current displayied frequency 2.5 KHz sideways
on 	        the P3 screen moving it close to the left side of
the
        display.  

BW280   Sets the Recieve bandwidth at 2.8 KHz, while leaving the 
        transmit at minimum...  

I do CW mostly so I want a small vertical line showing transmit
frequency.  

Hope this helps...
-- 
73's, and thanks,
Dave (NK7Z)

For software/hardware reviews see:
http://www.nk7z.net

For MixW support see:
https://groups.yahoo.com/neo/groups/mixw/info

For SSTV help see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info


On Fri, 2016-04-22 at 19:14 +0100, Tony G6GLP wrote:
> Hi All,
> I have noticed a little problem (not much) with the P3 display. I
> have  
> A K3 P3 and vga card set up as per the book and work fine until I go 
> from normal to split working. I achieve this with a macro on the K3.
> The 
> problem is the K3 goes into split but the display on the P3 and
> monitor 
> doesnt show the split until I move the sub rx and up it pops. Its not
> a 
> problem now I know about it but does anyone else see this or is
> there 
> something I could change to stop it.
> If more details are required I can copy out the macro (Not Mine) and 
> give a blow by low description.
> 
> 73 de Tony G6GLP
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at nk7z.net