[Elecraft] Rerouting the KRX3 AUX Input from the Rear BNC to the KAT3

[Don Wilhelm]

Sverre,

That task can be accomplished by removing only the top cover.

The angled TMP connector on the subRX is a little difficult to reach 
without tilting the back of the subRX up a bit, but it can be done.

73,
Don W3FPR

On 4/1/2016 1:56 PM, Sverre Holm (LA3ZA) wrote:
> When I built my K3 some years ago I routed the second receiver's AUX antenna
> input to the rear panel BNC connector. But now I have changed my mind and
> want to route it through the KAT3 instead, in order to try diversity
> reception.
>
> How complex is this to accomplish? I know I need to plug in another 30 cm
> tmp cable to the KRX3 board than the one I am using now.