[Elecraft] P3 Showing Transmit Signal

[Gene Gabry]

Just wanted to share this tip from Al, as it worked. Although, I started by reducing the polling by 50% first, and that did it. Ran a bunch of CQs with quick TX/RX switching and all N1MM+ functions running, and no freeze ups. Still don't know what path switched though on three of those hang ups over the weekend when I saw my TX signal in the P3 without the P3TXMON.

Thanks for the info Al.

73 Gene N9TF

K3S 10057 

-----Original Message-----
From: Al Lorona [mailto:alorona at sbcglobal.net] 
Sent: Tuesday, November 24, 2015 7:56 PM
To: Gene Gabry
Subject: Re: [Elecraft] P3 Showing Transmit Signal

Gene, you can tell N1MM+ to reduce the Radio Polling rate.

Go to Config --> Configure Ports, Mode Control, Audio, Other...

On the Hardware tab, click on the Set button for your K3 port and then select "100% Slower" from the Radio Polling list. This may help.

R,

Al  W6LX