[Elecraft] Setup P3, K3 using Microkeyer2

[Joe Subich, W4TV]

In addition to Don's comments, set the serial data rate to 38.400 bps
in the K3, microHAM USB Device Router and all your user applications.
The P3 sets the K3 to 38.400 when it is running and results will be
better if the P3 does not need to change data rate between the K3 and
computer applications.

73,

    ... Joe, W4TV


On 11/20/2015 10:48 AM, Don Wilhelm wrote:
> Kurt,
>
> Yes, move whatever you have currently connected to the K3 RS-232
> connector to the P3 PC RS-232 connector.
> That should work fine for all except for loading firmware.  To load K3
> (or P3) firmware, do *not* connect through the Microkeyer2, connect
> directly to a PC serial port or USB to serial adapter.
> See the cautions on the MicroHam website about attempting to load
> firmware with the MicroHam gear in-line.
>
> 73,
> Don W3FPR
>
> On 11/20/2015 10:34 AM, Kurt Wiksten wrote:
>> I have just bought the P3-kit to work with my K3 S/N 23xx.
>> According to the P3 manual, the Male – Female DE-9 cable
>> should be connected between the XCVR connector and K3:s
>> rear panel RS232 connector.
>> My present setup for the K3 is with Microkeyer2 as I am
>> working a lot of contests using N1MM+ for logging and Logger32 for
>> DX-ing.
>> The station computer is a HP Laptop, using one USB-port.
>>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to lists at subich.com