[Elecraft] Setup P3, K3 using Microkeyer2

[Don Wilhelm]

Kurt,

Yes, move whatever you have currently connected to the K3 RS-232 
connector to the P3 PC RS-232 connector.
That should work fine for all except for loading firmware.  To load K3 
(or P3) firmware, do *not* connect through the Microkeyer2, connect 
directly to a PC serial port or USB to serial adapter.
See the cautions on the MicroHam website about attempting to load 
firmware with the MicroHam gear in-line.

73,
Don W3FPR

On 11/20/2015 10:34 AM, Kurt Wiksten wrote:
> I have just bought the P3-kit to work with my K3 S/N 23xx.
> According to the P3 manual, the Male – Female DE-9 cable
> should be connected between the XCVR connector and K3:s
> rear panel RS232 connector.
> My present setup for the K3 is with Microkeyer2 as I am
> working a lot of contests using N1MM+ for logging and Logger32 for DX-ing.
> The station computer is a HP Laptop, using one USB-port.
>