[Elecraft] K3 Question on KXV3B

[Eric Swartz - WA6HHQ, Elecraft]

Yes, I believe.

Eric
/elecraft.com/

On 5/21/2015 7:55 AM, Ross Primrose wrote:
> I assume the new beta firmware (or a later stable release) is required to use 
> the KXV3B in a K3 (no S)?
>
> 73, Ross N4RP
>
> On 5/21/2015 10:42 AM, Wayne Burdick wrote:
>> The addition of the low-noise amplifier for 12-6 meters is the only change. 
>> The module is compatible with either the K3 or K3S. The manual will be posted 
>> when it's complete.
>>
>> 73,
>> Wayne
>> N6KR
>>
>> On May 21, 2015, at 7:22 AM, Bill Wiehe via Elecraft 
>> <elecraft at mailman.qth.net> wrote:
>>
>>> While reading the K3s FAQ's it says that the new KXV3B Interface board has 
>>> the new PR6-10 low-noise amplifier (LNA) as part of the circuitry. Further 
>>> reading suggests that this board can replace the KXV3A board in the K3.  I 
>>> have not been able to find the "manual" yet as I suspect it is still being 
>>> edited. I was just wondering if there were any other changes that needed to 
>>> be made to accommodate the swap as this sounds like an excellent upgrade for 
>>> the  K3.Bill-W0BBI
>>> ______________________________________________________________
>>> Elecraft mailing list
>>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>>> Help: http://mailman.qth.net/mmfaq.htm
>>> Post: mailto:Elecraft at mailman.qth.net
>>>
>>> This list hosted by: http://www.qsl.net
>>> Please help support this email list: http://www.qsl.net/donate.html
>>> Message delivered to n6kr at elecraft.com
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to n4rp at n4rp.com
>
>